PC55 Installation Page – Pedal Commander
Your cart is currently empty.
4th of July Sale is Here! 🔥🔥 Use USA35 at checkout, then get $35 OFF and a free Pedal Commander sticker! (While supplies last) 🚨

How to use

PC55 Installation

     PC55 3D Rendering

     lexus - lc 500

     LEXUS - RC F/350/300H/200T

     toyota - highlander


  • When installing the Pedal Commander, if the plugs are not fully locked in, they can become loose over time. To ensure you locked the plugs in place, you will want to hear a "click" sound when connecting the plugs. That "click" signifies that they have been locked in tight.
  • If you do not wait as explained and you unplug the gas pedal too soon, you will receive a check engine light because the vehicle's computer still has power and has detected a sensor was unplugged.

Step One - Turn off ignition.

  • Keep the key fob at least 35ft (10m) away from the vehicle. They key signal can give power to your vehicle's computer.
  • Wait 10-15 minutes with your driver door open to allow your ECU to shut down

Step Two - Plug in Pedal Commander.

  • Locate your accelerator pedal assembly plug connection
  • Remove the plug from your gas pedal
  • Plug male and female connectors into their coordinating plugs on the gas pedal. Make sure that both plugs "click" into place.

Step Three - Clean Up.

  • Make sure the cables are tucked in place so they do not affect or endanger your driving
  • Route the Pedal Commander to where you can access easily

Step Four - Mount.

  • Use the included alcohol wipe to clean the area where you would like the mount the bracket
  • Apply the supplied velcro to the bracket and cleaned area
  • Place the Pedal Commander into the bracket and you're done!